Questa è una vecchia versione del documento!
Implemented Codes
Lista dei G Code
Code | Description |
---|---|
G0 | G1 |
G1 | Coordinated Movement X Y Z E F(feedrate) P(Purge) |
G2 | CW ARC |
G3 | CCW ARC |
G4 | Dwell S[seconds] or P[milliseconds], delay in Second or Millisecond |
G5 | Bezier curve - from [forums.reprap.org](http://forums.reprap.org/read.php?147,93577) |
G7 | Laser raster base64 |
G10 | retract filament according to settings of M207 |
G11 | retract recover filament according to settings of M208 |
G12 | Nozzle Clean |
G20 | Set input units to inches |
G21 | Set input units to millimeters |
G27 | Nozzle Park |
G28 | X Y Z Home all Axis. M for bed manual setting with LCD. B return to back point |
G29 |
`G29 Fyyy Lxxx Rxxx Byyy` for customer grid. | | G30 | Single Z Probe, probes bed at current XY location. |
G31 | Dock Z Probe sled (if enabled) |
G32 | Undock Z Probe sled (if enabled) |
G33 |
```FPQ``` (Requires DELTA_AUTO_CALIBRATION_1)
```PV``` (Requires DELTA_AUTO_CALIBRATION_2)
```AERI D T S``` (Requires DELTA_AUTO_CALIBRATION_3) |
G38 | Probe target - similar to G28 except it uses the Z_MIN endstop for all three axes |
G42 | Coordinated move to a mesh point. (Requires MESH_BED_LEVELING or AUTO_BED_LEVELING_BILINEAR) |
G60 |
```S- specifies memory slot # (0-based) to save into (default 0)``` |
G61 |
```X Y Z E - Value to add at stored coordinates```
```F- Set Feedrate```
```S- specifies memory slot # (0-based) to restore from (default 0)``` |
G90 | Use Absolute Coordinates |
G91 | Use Relative Coordinates |
G92 | Set current position to cordinates given |
- Ultima modifica: 23/10/2017 17:36
- da Simone Persiani